The WS-35 provides protection of pipes, gas boilers, heat exchangers, shower cabins, plumbing fixtures, valves from limescale and “water stone”. It minimizes overconsumption of fuel and energy, reduces the likelihood of unplanned repairs, avoids reducing lifetime of household appliances and water heating equipment. WS-35 is suitable for use in mini-hotels, small family houses for 8-16 apartments, cafes, canteens, laundries.
WS-35 descaler (or scale remover, or water conditioner) is an electronic device that prevents scale formation in pipes, boilers and appliances, and does it without chemicals. Its operating principle is based on creating an electromagnetic field with a "standing wave" effect inside the plumbing system. The field push calcium ions - the main element of limescale, away from the surfaces of pipes, heating elements, and protects them from scale deposition. The device also softens and partially removes old scale.
Range of action. The field of the device extends along the pipes at a distance of about 50 meters, which is usually sufficient to protect the piping system of a low-rise house or mini-hotel.
WS-35 can operate in conditions of variable water flow, which is typical in residential homes. It also protects pipes when there is no water movement. It works on both metal and plastic pipes.
Using of one powerful descaler for several apartments is cheaper than to install a small device in each apartment.
Manufacturer: Gidroflou LLC, Russia.
Mounting on pipe with an outside diameter up to 2.3" (60 mm). it can be installed on pipes with a smaller diameter as well.
Water flow: from 0 to 9,0 m3/hour.
Self-diagnosis: yes, the data is displayed on the digital display.
Controls: signal level, temperature.
Warnings: overheating, low signal level, no ferrite.
Power supply voltage: 90-260 V.
Power consumption: 4,2 W.
Cable length: 5 m.
Package dimensions: 33x24x11 cm.
Weight of the package: 2.3 kg.
Cartoon contains: the descaler, 4 ferrite plates, 4 plastic bolts and nuts, ties for mounting the device, an operating manual.
The first non-chemical descalers appeared 50 years ago. WS-30 is a ferrite type device. It transmits the electromagnetic field to the water by induction, with a circular ferrite ring around the pipe. This minimizes losses (only 2-3%) in the transfer of energy into the water, and therefore ensures a high efficiency of the water treatment. WS-35 works successfully where previous generation devices (with wire windings around the pipe) were not efficient enough.
The choice of the descaler location.
The general rule: the device is installed on the pipe with cold water at the entrance to the house, after the pump, filter, water tank (if exist). For a system with water circulation the place of installation is after the circulation pump. To protect the heating system from scaling, basically another device is needed.
The device should not be placed on pipe joints and "combs". Do not place the device right next to the boiler, water heater. It is desirable that the distance (along the pipe) should be at least 50 cm. The shape of the pipe is not important. Straight part of the pipe for mounting is not necessary. In case of doubt, send us a picture or photo of the installation site.
We are looking for distributor in your area. For distributor we suggest special prices and technical support.
We expect you are active, mobile and competent person, who is interested to inform the customers about simple, cost-saving and non-chemical solutions of hard water problems.
We are with you at every step of communication with end-user.